Remove carpet trim, and pull back carpet and detner prior to running water test!

Using a water hose, spot test fro under the vehicle up toward the floor and rocker panel joint.

1.  Remove scuff plate and kick pad and pull back carpet.

2.   Rag dry floor before running water test.

3.  Following the water test, clean interior floor and rocker joint with a damp rag.

4. From inside the vehicle, seal the split seam at the rear area of the rocker with dum dum.

When spraying liquid metal inside the vehicle,
 remember to tell the customer that it takes
                     4 hours to cure. 
 The odor will dissipate during the curing time. 
 

 NEVER water test a vehicle immediately
 after using liquid metal during a repair.

    The vehicle should not be driven for up to 4 hours
    after the repair.  If that is not possible, be sure to relay
    that the windows must be kept down while driving.

  If still unsure of the repair, schedule a re-check
  within 7 days of the repair in order to water test.

Use of an inspection camera saves time and money!

Cut out and remove wet damaged detner, using a detner knife.

View of new detner.

FINISHED LOOK

Very Important Message: Although we demonstrate the steps to repair a complaint, it does not mean that the current repair is the ONLY repair nor the ONLY cause for a leak with the same complaint.